Komatsu Roller VOS 2-42A VOS T2-42A Shop Manual A-05.30 – PDF DOWNLOAD

Komatsu Roller VOS 2-42A VOS T2-42A Shop Manual A-05.30 – PDF DOWNLOAD

FILE DETAILS:

Komatsu Roller VOS 2-42A VOS T2-42A Shop Manual A-05.30 – PDF DOWNLOAD

Language : English
Pages : 182
Downloadable : Yes
File Type : PDF
Size: 32.4 MB

IMAGES PREVIEW OF THE MANUAL:

DESCRIPTION:

Komatsu Roller VOS 2-42A VOS T2-42A Shop Manual A-05.30 – PDF DOWNLOAD

CLEANING AND INSPECTION:

All parts must be clean to permit an effective inspection. During assembly, it is very important that no dirt or foreign material enters the unit being assembled. Even minute particles can cause malfunction of close fitting parts such as
thrust bearing, matched parts, etc.

A. Clean all metal parts thoroughly using a suitable cleaning fluid. It is recommended that parts be immersed in cleaning fluid and moved up and down slowly until all oils, lubricants, and/or foreign materials are dissolved
and parts are thoroughly clean.

B. For bearings that can be removed, soak them in a suitable cleaning fluid for a minute or two, then remove bearings from cleaning fluid and strike flat against a block of wood to dislodge solidified particles of lubri- cant. Immerse again in cleaning fluid to flush out particles. Repeat above operation until bearings are thoroughly clean. To dry bearings, use mois- ture-free compressed air. Be careful to direct air stream across bearing to avoid spinning bearings that are not lubricated. DO NOT SPIN BEARINGS WHEN DRYING; bearings may be rotated slowly by hand to facilitate drying pro~ cess.

For those bearings that are to be inspected in place, compressed air can be used to sufficiently clean these bearing for inspection.

TABLE OF CONTENTS:

Komatsu Roller VOS 2-42A VOS T2-42A Shop Manual A-05.30 – PDF DOWNLOAD

GENERAL TORQUE VALUES
SPECIAL TOOLS
INTRODUCTION
SERVICINGCLEANING AND INSPECTIONREASSENBLY
START-UP PROCEDURE
BRAKE ADJUSTMENT
TESTING