Kymco GRAND DINK 125/150 Service Manual - PDF DOWNLOAD

Kymco GRAND DINK 125/150 Service Manual - PDF DOWNLOAD

FILE DETAILS:

Kymco GRAND DINK 125/150 Service Manual - PDF DOWNLOAD

Language : English
Pages : 224
Downloadable : Yes
File Type : PDF

IMAGES PREVIEW OF THE MANUAL:

TABLE OF CONTENTS:

Kymco GRAND DINK 125/150 Service Manual - PDF DOWNLOAD

GENERAL INFORMATION 1EXHAUST MUFFLER/FRAME COVERS 2INSPECTION/ADJUSTMENT 3LUBRICATION SYSTEM 4ENGINE REMOVAL/INSTALLATION 5CYLINDER HEAD/VALVES 6CYLINDER/PISTON 7DRIVE AND DRIVEN PULLEYS/KICK STARTER 8FINAL REDUCTION 9A.C. GENERATOR/STARTER CLUTCH 10CRANKCASE/CRANKSHAFT 11COOLING SYSTEM 12FUEL SYSTEM/CARBURETOR/FUEL PUMP FUEL TANK 13STEERING HANDLEBAR/FRONT WHEEL/FRONT BRAKE/FRONT SHOCK ABSORBER/FRONT FORK 14REAR BRAKE/REAR FORK/REAR WHEEL/REAR SHOCK ABSORBER` 15BATTERY/CHARGING SYSTEM 16IGNITION SYSTEM 17STARTING SYSTEM 18SWITCHES/HORN/FUEL UNIT/ THERMO-STATIC SWITCH/TEMPERATURE GAUGE/INSTRUMENTS/ LIGHTS 19

DESCRIPTION:

Kymco GRAND DINK 125/150 Service Manual - PDF DOWNLOAD

PREFACE:

• This Service Manual describes the technical features and servicing procedures for the KYMCO GRAND DINK 125/150.
• Section 1 contains the precautions for all operations stated in this manual. Read them carefully before any operation is started.
• Section 2 is the removal/installation procedures for the frame covers which are subject to higher removal/installation frequency during maintenance and servicing operations.
• Section 3 describes the inspection/ adjustment procedures, safety rules and service information for each part, starting from periodic maintenance.
• Sections 5 through 13 give instructions for disassembly, assembly and adjustment of engine parts. Section 14 is the removal/ installation of chassis. Section 16 states the testing and measuring methods of electrical equipment.
• Most sections start with an assembly or system illustration and troubleshooting for the section. The subsequent pages give detailed procedures for the section

GENERAL INFORMATION:

 GRAND DINK 125/150 SERVICE PRECAUTIONS

• Make sure to install new gaskets, O-rings, circlips, cotter pins, etc. when reassembling. 
• When tightening bolts or nuts, begin with larger-diameter to smaller ones at several times, and tighten to the specified torque diagonally. 
• Use genuine parts and lubricants. 
• When servicing the motorcycle, be sure to use special tools for removal and installation. n After disassembly, clean removed parts. Lubricate sliding surfaces with engine oil before reassembly. 
• Apply or add designated greases and lubricants to the specified lubrication points. 
• After reassembly, check all parts for proper tightening and operation. n When two persons work together, pay attention to the mutual working safety.
• Disconnect the battery negative (-) terminal before operation. 
• When using a spanner or other tools, make sure not to damage the motorcycle surface. 
• After operation, check all connecting points, fasteners, and lines for proper connection and installation. 
• When connecting the battery, the positive (+) terminal must be connected first. 
• After connection, apply grease to the battery terminals. 
• Terminal caps shall be installed securely.

G.B 15/03/25