Volvo Penta D4, D6, D9, D12, D16 Electronic Vessel Control EVCEC-C Installation Manual_51339553 PDF

Volvo Penta D4, D6, D9, D12, D16 Electronic Vessel Control EVCEC-C Installation Manual_51339553 – PDF DOWNLOAD

FILE DETAILS:

Volvo Penta D4, D6, D9, D12, D16 Electronic Vessel Control EVCEC-C Installation Manual_51339553 – PDF DOWNLOAD

Language : English
Pages : 138
Downloadable : Yes
File Type : PDF

TABLE OF CONTENTS:

Volvo Penta D4, D6, D9, D12, D16 Electronic Vessel Control EVCEC-C Installation Manual_51339553 – PDF DOWNLOAD

Safety precautions 5
General information 7
Engine monitoring and the EVC system 10
Engine monitoring system 10
The EVC-C system 11
Installation tools and literature 13
Other special equipment 14
Major components 15
General view 15
Installation procedure, general 28
Cable routing 29
Marking and color coding of cables 32
Building an EVC network 33
Identification of the PCU and the HCU 34
Installation procedure, engine room 35
Location and mounting of the PCU and HCU 35
Engine–PCU cable, stern drive 36
Engine–PCU cable, Inboard engine 36
Transmission cables 37
Checking rotation of propeller, D4/D6 38
Checking rotation of propeller, D9/D12/D16 39
Volvo Penta Lowspeed and Trolling 42
PCU, installation 43
Fuel and fresh water level senders 43
Rudder indicator 46
Standard bus cable PCU–HCU 45
HCU, installation 47
Powertrim system, D4/D6 stern drive 48
Gear shift actuator, D4/D6 stern drive 48
© 2007 AB VOLVO PENTA
All rights to changes or modifications reserved
Printed on environmentally-friendly paper
Contents cont
Installation procedure, helm 49
Y-connector 49
Key switch and relay 49
Start/stop panel 50
EVC control panel 52
Powertrim panel 54
Relay for external accessories 55
Instruments 57
Instrument, panels and auxiliary cable 59
Buzzer 60
Auxilliary dimmer unit (ADU) 61
Synchronizing cable, twin installtions 62
EVC system display 63
NMEA 0183 interface 68
NMEA 2000 interface 69
Multisensor 71
Controls, electronic 72
Adapter for mechanical controls 75
Controls, mechanical 76
Interface 4–20 mA 79
EVC control panels 82
Calibration and settings 83
General 83
Calibration mode 84
Auto configuration 84
EVC control lever combinations
Calibration summary 86
Lever calibration 88
Select language and units 91
Powertrim calibration 92
Powertrim Assistance, PTA 93
Trolling calibration 94
Slip calibration 95
Idling speed calibration 96
OEM-mode 97
Fuel tank settings 97
Fuel tank calibration 98
Multisensor calibration 100
EVC system display 102
Diagnostic function 107
Fault register 109
Parameter settings 117
Starting the engine 119
Wiring color and pin-out schematics 123
Templates for controls and panels 125
References to Service bulletins 136

DESCRIPTION:

Volvo Penta D4, D6, D9, D12, D16 Electronic Vessel Control EVCEC-C Installation Manual_51339553 – PDF DOWNLOAD

Safety precautions:
Introduction:

• This Installation Manual contains the information you will need to install and test the Electronic
  Vessel Con- trol (EVC) system.
• Read this Installation Manual carefully before instal- lation. Incorrect installation may result in
  personal injury or damage to property or the engine itself.
• If you do not understand or are uncertain about any operation or information in this Installation
  Manual, please contact the Volvo Penta organization.

Installation:

• This Installation Manual is intended for professional use only.
• The Manual must be used in conjunction with the rel- evant Engine Operator’s Manual.
• Volvo Penta will not assume any liability for damage to materials or personal injury, which may
  result if the installation instructions are not followed or if the work is carried out by
  non-professional personnel.
• The installer is responsible for ensuring that the system operates in accordance with this
  Installation Manual.

Work procedures:

• These instructions are for use by suitably qualified personnel, referred to as the installer in
  these instructions.
• Refer to the specific Engine Operator’s manual for relevant information where necessary, especially
  regarding safety and engine operation.
• The work must be done at Volvo Penta’s service workshops, boat builders or other authorised and
  suitably equipped workshops with personnel who have the appropriate qualifications and experience.

IMAGES PREVIEW OF THE MANUAL: